Facebook
Description

Repair To Road Pot Holes Road Shoulder Road Berms Hardstanding Road Furniture And Certain Connecting Work At Eastern Complex Of Mcte Area Under Ge Mcte Mhow

Tendering Authority: Military Engineer Services

India, Madhya Pradesh, MHOW

NTID

29363479

Last Date For Submission

03 Nov, 2022

Closing Date

03 Nov, 2022

BOQ Items Total Items : 17 | Total Qty : 2885.7
# Item Quantity Units
1 M&L for preparing surfaces of existing black top surface with wire brushes for removing caked mud etc and sweeping with brooms and finally fanning to clean the surfaces with gunny bags to remove all loose dirt etc and M&L for applying evenly a priming coat/tack coat with hot pressure spray using SS(slow setting) bitumen cationic emultion conforming to IS-8887/ASTMD -2397 @ 7.5 kg/10 Sqm over old bitumious surface allowing it to penetirate atleast 5 to 10mm from top surface of old bitumen and M&L for premixed hot mix Asphaltic Semi Dence (SDAC) Concrete using 5.5% binder content (VG-30 Grade paving bitumen) by weight of total mix and with thickness of 30 mm (consolidated Thickness) including rolling with 8 to 10 tonne power road roller to uniform and smooth surface and consolidation to required gradient and camber all as specified and directed. 890.00 Ten Sqm
2 Note1 : Cement shall be used as filler at mininum 2% by weight of total mix in event of variation in design mix the percentage of filler content shall be on plus side adopted. (b)SDAC shall be as per MORTH specification Note2: - (i) Laying shall be done by means of self-propelled mechanical paver, finishing with electronic sensor and hydraulic controls with suitable speed and capable of laying, spreading, tamping and finishing. (ii) Mix shall be obtained from computerized hot mix plant and spreading shall be done by using mechanical paver only) (iii) The mix shall be designed by job mix formula and approved by GE. (iv) Cost of testing charges, materials and transportation etc for job mix formula and Independent testing during execution of work shall be inclusive in the unit rate quoted and no extra payment shall be made on this account.
3 M&L for applying evently a priming coat/tack coat with hot pressure spray using RS(rapid setting) bitumen cationic emultion conformation tp IS-8887/ASTMD-2397 @ 2.5 kg/10 Sqm over bitumious maccadam/ Black top surface all as specified and directed. 890.00 Ten Sqm
4 M&L for pre mix Dense Bituminius Macadam (DBM) 75mm (Consolidated thickness) lade in single layer using 5.5% minimum binder content by weight of total mix, with paying bitumen of grade VG-30 penetraton using hot mix plant laid by using mechnical sensor paver, rolled and consolidated to required gradient and camber using vibratory/pneumatic and tanderm vibratory roller of capacity exc 8 tone but n.exceeding 12 tone capacity complete all as specified. Note: Marshal stability shall be of minium 900 kg (c) DBM shall be as per MORTH Specification as detailed in particular specition. 6.20 Cum
5 M&L for making lines, dashes, arrows, letters etc not exceeding 15 cm wide on bituminous surface with retro reflective thermoplastic road marking paint with reflector sing glass beads @ 250 gms per sqm area confirming to MOST & BIS specification, not less than 2.00 mm thick of white/golden/yellow as approved colour/shade and applied with machine, as per manufacturer's instructon inccluding preparation of surface i.e. cleaning of surface by removing all dust, dirt, oil grease etc complete all as specified and as directed. 90.00 Sqm
Tender InquiryInquiry